The Hundegger Wire Chase machine was developed for our SIPs customers. Hundegger has always taken the experience and "know how" that we have accumulated in building machines over the past 30 years, and incorporated it, along with customer feedback, into the development of other Hundegger machines.

The idea of our wire chase machine was derived from customer feed-back. The Hundegger PBA has proven to be the machine of choice for today’s SIP manufactures choosing to automate their fabrication. Some of our PBA customers looked to Hundegger for a way to automate the drilling of foam, rather than "Hot Wire" every piece of EPS that goes into a panel.

Immediately, the customers realized the value of the Hundegger Wire Chase Driller. Now you have the capability of drilling only the panels that need a wire chase.

Drill units: 2 units at end (left and Right) drill Depth 12’- 5 ½" (3800mm); 1 unit at front, Drill depth 9’- 43/16" (2850mm)

Drill Diameter: 1.5" Ø39mm

 Maximum Panel Dimension: 25’ x 9’-2"

Minimum Panel Dimension: 1.5’ x 1.5’

Maximum Panel Thickness: 12.25"

Minimum Panel Thickness: 4.25"

Manual Drill Feed rate = approx. 12 ft/min

Table Height: 22.5"

Vacuum for each drill unit: hose diameter Ø38mm ID

Required vacuum capacity for each drill unit: 220 cfm

Panel is to be held in place by manually positioned "Quick Clamps"Electrical connection: USA/Canada: 3 Phase~60 Hz 480 V (2 kW)

Pneumatic connection required: Yes, for the retractable table rollers – (vacuum to be supplied by customer)

Electrical Primary feed from existing service to the machine is to be supplied and installed by customer.

Wire Chase Video